2.3.3.2 General Escape Syntax

In addition to the specific excape sequences for special important control characters, Emacs provides general categories of escape syntax that you can use to specify non-ASCII text characters.

For instance, you can specify characters by their Unicode values. ?\unnnn represents a character that maps to the Unicode code point ‘U+nnnn’. There is a slightly different syntax for specifying characters with code points above #xFFFF; \U00nnnnnn represents the character whose Unicode code point is ‘U+nnnnnn’, if such a character is supported by Emacs. If the corresponding character is not supported, Emacs signals an error.

This peculiar and inconvenient syntax was adopted for compatibility with other programming languages. Unlike some other languages, Emacs Lisp supports this syntax in only character literals and strings.

The most general read syntax for a character represents the character code in either octal or hex. To use octal, write a question mark followed by a backslash and the octal character code (up to three octal digits); thus, ‘?\101’ for the character A, ‘?\001’ for the character C-a, and ?\002 for the character C-b. Although this syntax can represent any ASCII character, it is preferred only when the precise octal value is more important than the ASCII representation.

?\012 ⇒ 10         ?\n ⇒ 10         ?\C-j ⇒ 10
?\101 ⇒ 65         ?A ⇒ 65

To use hex, write a question mark followed by a backslash, ‘x’, and the hexadecimal character code. You can use any number of hex digits, so you can represent any character code in this way. Thus, ‘?\x41’ for the character A, ‘?\x1’ for the character C-a, and ?\x8e0 for the Latin-1 character ‘a’ with grave accent.

Ce document a été généré par Eric Reinbold le 13 Octobre 2007 en utilisant texi2html 1.78.