| [ < ] | [ > ] | [ << ] | [Plus haut] | [ >> ] | [Top] | [Table des matières] | [Index] | [ ? ] |
You can use mouse clicks on window mode lines to select and manipulate windows.
Some areas of the mode line, such as the buffer name and the major mode name, have their own special mouse bindings. These areas are highlighted when you hold the mouse over them, and information about the special bindings will be displayed (voir la section Tooltips). This section's commands do not apply in those areas.
Mouse-1 on a mode line selects the window it belongs to. By dragging Mouse-1 on the mode line, you can move it, thus changing the height of the windows above and below. Changing heights with the mouse in this way never deletes windows, it just refuses to make any window smaller than the minimum height.
Mouse-2 on a mode line expands that window to fill its frame.
Mouse-3 on a mode line deletes the window it belongs to. If the frame has only one window, it buries the current buffer instead, and switches to another buffer.
C-Mouse-2 on a mode line splits the window above horizontally, above the place in the mode line where you click.
Using Mouse-1 on the divider between two side-by-side mode lines, you can move the vertical boundary left or right. Using C-Mouse-2 on a scroll bar splits the corresponding window vertically. Voir la section Splitting Windows.
Ce document a été généré par Eric Reinbold le 23 Février 2009 en utilisant texi2html 1.78.